Tile is sensitive, yet you need to drill it for various reasons. Indeed, you will need to drill the tile to install a kitchen cabinet. Furthermore, to replace a damaged tile, install a recessed switch on a tiled wall, you must drill into the tile. Similarly, it will be necessary to install an electrical outlet, etc. However, to successfully drill, you will need a sophisticated tool. Among the tools available today, there is the saw. So, how do you drill tile with this saw? The answers are in the following lines.
Prepare the area to be drilled
With a saw such as the radial saw found on scie-radiale.net, you can drill tile. To do this, you need to properly prepare the area where you want to work. Indeed, you should know that tile has good resistance, but when drilling, it can also break easily. If it appears fragile, this is mainly due to the pressure you will exert on it. However, you cannot afford to make a mistake, as you cannot treat a cracked tile the same way as a well-drilled tile.
Read also : How to Spot a Womanizer: Telltale Signs and Attitudes to Observe
It is then important to estimate the drilling points. Next, you will transfer the ideal measurement for the size you want to achieve. After that, you will place tape on the area to mark the measurement. You have just made a good delineation of the part to be drilled. With the tape and this delineation you just made, you can be sure that you will not slip while drilling. It should be noted that your tape must be clear.
Now make your cut
If you have the option to use a variable speed saw, this is desirable for the work you will be doing here. Also, with a diamond blade, for example, you will succeed well in your task. To make your cut, it is also recommended to add a little water to avoid, among other things, the bursting of your tile. It should be noted that the tile must remain permanently moist during the work. If the drilling is to be done with a hole saw, you must first mark the center drill and the hole saw. Now, you need to drill slowly to avoid damaging your tile.
Further reading : How to find the critical path in a project?
It is strictly forbidden to apply strong pressure on your hole saw here. You may also be facing an uninstalled tile. In this case, it is advisable to turn the tile over before drilling it. Then, you will continue the work on the new face that is facing you. When the tile is not yet installed, it can be placed on a wooden board. This will absorb the various vibrations. To drill the tile, you can also simply use a drill bit. Here too, you must operate at a lower and consistent speed while properly holding your drill. If you need to drill ceramic tile, opt for a carbide bit. For glazed stoneware tile, use a bit with a diamond segment head.